Cleaning And Maintenance; Storage; Troubleshooting - Brewista NutraMilk BRNMC2L Serie Mode D'emploi

❺ Cleaning and Maintenance:

This appliance contains no user-serviceable parts and requires little maintenance.
•
◦ Refer any servicing or repairs to qualified personnel.
Clean your NutraMilk regularly.
•
◦ Clean the outside of the base (8) and the attached arm (7) with a damp, soft
cloth (Illus. L). Use the included brush to clean the mesh portions of the inner
filter (5).
Disassemble and clean the basins, blades, and wiper blades with dish detergent and
•
rinse thoroughly with water OR wash in a dishwasher (top rack recommended).
◦ Do not use abrasive cleaners.
◦ All parts except the base (8) are dishwasher safe - top rack recommended.
◦ After cleaning, dry all components thoroughly prior to storage.
WARNING: Never immerse the base in water or other liquids (Illus. M).
WARNING: Always unplug the appliance prior to cleaning.

❻ Storage:

• Clean and dry all parts before storing.
• Store the NutraMilk in its box or in a clean, dry place out of reach of children.
• Never wrap the power cord around the appliance.

❼ Troubleshooting:

If the LCD displays "Er" when any function button is pressed, the components have
•
not been assembled correctly. Unplug the unit and re-assemble its components.
If the wiper drive gear (6) does not line up when lowering the arm (7) into place,
•
rotate the wiper blades (2) a quarter turn by hand and lower arm again.
• LCD displays "OL" - The NutraMilk is equipped with overload protection to protect it
from electrical overload. When a power overload is detected, the LCD display will
blink "OL" and all button lights will blink. Unplug the unit and ensure there is nothing
blocking the blades.
• START/STOP button (22) is not working - If no function was chosen prior to pressing
the START/STOP button (22), the LCD readout (16) will blink "00" for 3 seconds.
Choose a function button (BUTTER, MIX, or DISPENSE) and press the START/STOP
button (22) again.
L M
9