Operation Instructions; Assembling The Nutramilk; Making Alternative Butter - Brewista NutraMilk BRNMC2L Serie Mode D'emploi

Operation Instructions

Note: Before using the NutraMilk for the first time, be sure to wash all components as
recommended in the Cleaning Section of these instructions (see page 9).
❶ Assembling the NutraMilk (Refer to Components List on Page 5):
Set the base (10) on a flat, steady surface with arm (7) tilted up away from the base.
•
Place the mixing basin (8) on the center of the base with spigot hole at the front.
•
Twist to lock in place.
•
Insert neck of the dispensing spigot (11) into hole at front of the mixing basin (8) until
•
it clicks into place.
Rotate the lid (1) counter-clockwise to unlock and remove.
•
Insert the inner filter (5) within the mixing basin (8) and center it into position.
•
Carefully align cutting blade (3) with center post of base and press firmly to install.
•
WARNING: LACERATION HAZARD - Handle blade carefully; it is very sharp.
Make sure unit is unplugged before installing or removing blade.
• Place wiper blades (2) into inner filter (5).
Replace lid (1) and twist clockwise to lock into place.
•
Lower arm (7) to lock into top of lid (1). If the wiper drive gear (6) does not line up
•
when lowering the arm (7), rotate the wiper blades (2) a quarter turn by hand and
lower arm again.
Plug the power cord (12) into a grounded wall outlet (Illus. A) and press the power
•
switch (14) at the back of the appliance (Illus. B). The LCD readout (16) will display
"00".
Notes:
◦ Before plugging the NutraMilk machine into a wall outlet, check that the
electrical circuit is not overloaded with other appliances.
◦ If the LCD displays "Er" when any function button is pressed, the components
have not been assembled correctly. Unplug the unit and re-assemble its
components.

❷ Making Alternative Butter:

Ensure that the cutting blade is properly positioned.
•
• Fill the inner filter (5) with your preferred nut or seed (Illus. C).
◦ If you intend to make alternative milk from this butter, the minimum amount
of ingredients is 1 cup.
◦ If you intend to make alternative butter, a minimum 2 cups of ingredients are
required. Refer to our Recommended Ratios & Processing Times chart on page
10 for guidance.
Press the BUTTER button (Illus. D) and then the START/STOP button (22) (Illus. E) to
•
begin the process of making butter.
6
A B