Table des Matières
Publicité
Anleitung NHS 700_SPK1
GB
7. Tips on use
The hedge trimmer can be used not only for
b
trimming hedges but for trimming shrubs
and bushes as well.
For optimum trimming performance, guide
b
the blade teeth at an angle of approx. 15° to
the hedge (see Fig. 10).
Since the blades cut on both sides and run
b
in opposite directions to each other, you
can trim in both directions (see Fig. 11).
To achieve a hedge with a uniform height it
b
is recommended that you stretch a piece of
string along the edge of the hedge for gui-
dance. Then simply cut away all twigs pro-
jecting above the line (see Fig. 12).
The sides of the hedge should be trimmed
b
with arc-type movements from below
upwards (see Fig. 13).
Operation with the trimmings collector
b
(Fig. 18/19)
For horizontal trimming it is recommended
that you attach the trimmings collector. This
enables the trimmings to be removed more
easily, keeping the surface of the hedge
tidier in the process.
8. Care, maintenance and
storage
Always switch off the machine and pull the
b
plug before you start to clean the machine.
For optimum results at all times you should
b
regularly clean and lubricate the blades.
Remove any deposits with a brush and
apply a light film of oil (see Fig. 14).
Use biologically degradable oil.
Clean the plastic body with gentle domestic
b
cleaning agent and a damp cloth. Never
use aggressive media or solvents.
It is imperative that you prevent water from
b
penetrating the machine. Never spray the
machine down with water.
When not in use the hedge trimmer can be
b
hung on the wall with a suitable screw and
dowel (see Fig. 15).
18
01.09.2006
11:37 Uhr
9. Faults
b
10. Disposal
Important!
The hedge trimmer and its accessories are
made of a diversity of materials such as, e.g.
metal and plastic.
Defective parts must be disposed of as special
waste. Ask your specialist dealer or local
authority for details about where they can be
disposed of!
11. Ordering replacement parts
Please quote the following data when ordering
replacement parts:
For our latest prices and information please go
to www.isc-gmbh.info
Seite 18
The machine does not start: Check that the
power cable is correctly connected and
check the mains fuses. If the machine still
does not work even with connected voltage,
please send it to the specified customer
services address.
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part
required
Publicité
Table des Matières
