Zephyr Essentials Tempest I AK7000BS Guide D'utilisation, D'entretien Et D'installation page 17

Blower On/Off
1. Blower On/Off
By pressing the blower is switched on and off. When switched on, the blower starts up on speed level 1.
ACT Verification
- Airflow Control Technology (ACT) allows the installer to set the maximum blower CFM to align with local codes and regulations.
- To verify the maximum blower CFM:
- With hood off, hold the
390 CFM, and if number 2 displays = max. 290 CFM.
2. Speed Selection
The 6 speed levels are selected by pressing
selected.
ACT Enabled Speed Selections
- When ACT is enabled, the number of blower speeds will be reduced as follows:
- 390 CFM = Maximum 3 speeds
- 290 CFM = Maximum 2 speeds
3. Delay Off
This feature is used for programmed shut down of blower 5 minutes after the function is activated. Press
in the lower right side of display
4. Lights On/Dim/Off
Switch lights on by pressing
5. Display Window
The display window indicates speed levels and features such as baffle filter clean reminder, delay off and clean air indicator.
Display (speed level, delay off, filter clean)
Adjust 6 Speed Levels
button for 3-4 seconds. If number 6 displays = default max. CFM, if number 3 displays = max.
to decrease and
indicating the function is on. The blower will completely shut down after 5 minutes.
once, press a second time to dim and again to shut off lights.
15
Lights On/Dim/Off
5 Min Delay Off
to increase speed levels. The display indicates levels
once, a dot flashes