User manual
The projector can be installed on the floor resting on special rubber feet, on a truss or on theceiling or
wall. WARNING:with the exception of when the projector is positioned on the floor, the safety cable
must be fitted. This must be securely fixed to the support structure of the projector and then connected
to the fixing point at the centre of the base.
In DMX Controller mode, at the last fixture in the chain, the DMX output has to be connected with a DM
X terminator. This prevents electrical noise from disturbing and corrupting the DMXcontrol signals.
The DMX terminator is simply an XLR connector with a 90 - 12 0Ω (ohm) 1/4 watt res is to rconnected
across pins 2 and 3 o f a male XLR connector (DATA+ and DATA-). This terminator is then p lugged into the
output socket o n the last fixture in the daisy chain to terminate the line.
BSW 17R IP
14