AquaScape AQUAFORCE 1000 Manuel D'instructions Et D'entretien page 5

Threaded Collar
• The extremely
versatile Rotational
Ball Outlet provides
you the ability to
adjust the pump discharge to the perfect position that your
water feature set-up requires. Loosening the threaded
collar allows you to rotate the upper half of the ball. A fl at
rubber washer seal is included to ensure a hand-tight and
leak-free connection. Make sure the fl at rubber washer is
in place before installing the fi ttings.
• Install the right-
sized Multi-Hose
Adapter, based
on the diameter of
the tubing you are
using.
• The AquaForce includes a
®
wide assortment of fi ttings
to choose from. Select the
appropriate fi tting(s) needed
for your application.
• The threaded collar, on
all of the fi ttings, enables
the AquaForce pump to
®
be installed and removed
without the need for any
tools. Do not use tools to
attach the fi ttings onto the
pump discharge. Fittings
need to be hand-tightened
only.
• Attach tubing to the fi tting. If tubing is loose on the fi tting,
use a hose clamp (not included) to secure tubing onto the
fi tting.
• Connect the other end
of the pump tubing to
the pond fi lter, such
as a biological fi lter,
waterfall spillway or
pressurized fi lter.
• Connect the pump to an outlet that is protected by a
ground fault interrupter. Once the pump is running and
water is circulating, check for any leaks where the external
connections are made.
• If using pipe with a larger
diameter than the smaller
fi ttings of the Multi-Hose
Adapters, cut off the
smaller section to avoid
any fl ow restriction.
5