Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
lubrICAtIon And oIl
Do not attempt to operate this air
CAUTION
compressor without first verifying
the oil level in the crankcase. This compressor is
shipped with oil in the crankcase. Serious damage
of the compressor can result from even momentary
operation without proper lubrication.
Prior to each use, verify the crankcase oil level. An
oil sight gauge with minimum and maximum oil level
marks is provided with this compressor.
Always verify that the oil level is at the maximum
mark in the oil sight gauge before operating this unit.
Do not operate the pump with an inadequate or ex-
cessive amount of oil. The cost of failures which oc-
cur due to incorrect oil levels will not be covered un-
der warranty.
To check the oil level:
1. Place unit on a level surface.
2. Remove dipstick, wipe with a clean rag, replace
in crankcase, then remove dipstick to inspect oil
level.
3. If oil level is low, add as required, but do not exceed
maximum oil level.
MAX
MIN
Do not allow particulates such as
CAUTION
sawdust to fall into crank case when
crank case is open for inspection. Particulates in oil
may reduce compressor life.
Do not use a detergent oil in
CAUTION
crankcase. Detergent oils will leave
deposits on internal compressor components
reducing compressor life and performance.
dIreCtIons for InstAllInG WHeels
(Cet20-W only)
1. Take wheel spindle (A) and thread into wheel
bracket (B), which is welded to compressor frame.
Tighten spindle with wrench to secure to frame.
2. Slide wheel onto wheel spindle. Inflation stem for
wheel assembly should face toward the compressor
8
Assembly / InstAllAtIon
Fig. 1
frame.
3. Place screw through washer (D) and thread screw
into end of wheel spindle (C). Tighten screw to
secure to spindle.
4. Repeat these steps for second wheel.
(D)
(C)
(A)
Fig. 2
GroundInG
This product must be grounded. In the event of an
electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the
electric current. This product is equipped with a cord
having a grounding wire with an appropriate ground-
ing plug. The plug must be inserted into an outlet that
is properly installed and grounded in accordance with
all local codes and ordinances.
Improper
WARNING
grounding plug is able to result in
a risk of electric shock. When repair or replacement
of the cord or plug is required, do not connect the
grounding wire to either flat blade terminal. The wire
with insulation having an outer surface that is green
with or without yellow stripes is the grounding wire.
Check with a qualified electrician or serviceman when
the grounding instructions are not completely under-
stood, or when in doubt as to whether the product is
properly grounded. Do not modify the plug provided;
if it does not fit the outlet, have the proper outlet in-
stalled by a qualified electrician.
GROUNDED
OUTLET
GROUNDING
PIN
Fig. 3
(B)
installation
of
GROUNDED
OUTLET BOX
the
Publicité
Table des Matières
