Weller WR 2 Notice D'utilisation page 32

12-20
Settings
SETBACK OFF Time
Time [1-99 min] [1-999 min]
0
0
ON
0
Time
ON
Time 0
Time Time
0 0
ON 0
0 Time
ON Time
Time 0
Time Time
1) Not in use = UP/DOWN buttons not pressed and no temperature drop > 5 °C.
STANDBY temperature must be below the set setpoint temperature, otherwise the SETBACK
2)
function is inactive.
3) When a switching holder is connected, the soldering tool always remains at the set setpoint
temperature outside the holder. The holder function is not activated until the soldering tool has been
placed in the holder for the first time.
1. Select the menu item OFF in Menu 1.
2. Set the AUTO-OFF setpoint time value with the UP or DOWN
button.
3. Change to the next menu option using the ┌ 1 ┐ (back) or ┌1·2┐
(forwards) button.
4. Special Button ON/OFF
ECO function ON/OFF
Temperature performance with different settings of the SETBACK
and AUTO OFF functions
Temperature performance without switching holder
Soldering tool remains at the set soldering temperature.
Soldering tool is switched off when not in use
has elapsed.
When the soldering tool is not in use
the STANDBY temperature
When the soldering tool is not in use
the STANDBY temperature
and the tool is switched off after the OFF time has elapsed.
Temperature performance with switching holder
Soldering is switched off in the holder
Soldering tool is controlled down in the holder
temperature .
2)
Soldering tool is switched off in the holder
elapsed.
The temperature of the soldering tool in the holder
the STANDBY temperature
OFF time has elapsed.
The temperature of the soldering tool in the holder
the STANDBY temperature
The temperature of the soldering tool in the holder
the STANDBY temperature
and the tool is switched off after the OFF time has elapsed.
Note Reset of STANDBY and OFF modes:
 without switching holder by pressing the UP or DOWN button.
 with switching holder by removing the soldering tool from the
holder.
1) after the OFF time
1) the temperature is reduced to
2) after the SETBACK time has elapsed.
the temperature is reduced to
1)
2) after the SETBACK time has elapsed
.
3)
to the STANDBY
3)
3) after the OFF time has
and the tool is switched off after the
2)
after the SETBACK time has elapsed.
2)
after the SETBACK time has elapsed
2)
WR 2
3) is reduced to
is reduced to
3)
is reduced to
3)