Warning; Caution; Note; Information Plates And Symbols On The Product - Clatronic MWG 777 U Mode D'emploi

On the top of the microwave there is a hazard symbol with the following text:
During operation the temperature of the exposed surface may be very hot. Danger of burns!
On the back of the microwave there is an information plate with the following text:

WARNING

• MICROWAVE AND HIGH VOLTAGE INSIDE. BE SURE NOT TO REMOVE THE ENCLOSURE.
• THIS APPLIANCE IS EQUIPPED WITH A GROUNDED PLUG FOR YOUR PROTECTION AGAINST POS-
SIBLE SHOCK HAZARDS AND SHOULD BE CONNECTED TO A PROPERLY GROUNDED OUTLET.
• THIS DEVICE IS TO BE SERVICED ONLY BY PROPERLY QUALIFIED SERVICE PERSONNEL.
• DISCONNECT POWER PLUG BEFORE SERVICING. REMOVAL OF THE ENCLOSURE WITH PRODUCT
ENERGIZED COULD EXPOSE SERVICEMEN TO HAZARDOUS HIGH VOLTAGE POTENTIAL.

Overview of the Components

1 Power control
2 Timer
3 Door opener
4 Grilling grid
5 Drive axle
6 Slide ring
7 Revolving tray
8 Door lock
9 Viewing window
Avoiding the Danger of Fire
when Installing as a Bottom-Mounted Device
If you would like to install the microwave as a bottom-mounted device
on a cupboard or shelf, for example, please note the information in the
section "Installation Instructions for Bottom-Mounted Devices".
• Do not remove the feet on the underside of the device.
• Please use only the attachment materials supplied if you want to
install the microwave under a cupboard.
• Maintain the following distances between the sides of the device
and the furniture when installing the microwave:
• 1.5 cm to the right-hand side
• at least 10 cm to the ventilation slits on the left-hand side.
• To not cover any openings! Otherwise ventilation of the device
will not be sufficient.
• The distance to the back wall is guaranteed by means of a
spacer.
• The back wall has to be fireproof (e.g. tiles).
32

Information Plates and Symbols on the Product

WARNING-
MICROWAVE ENERGY-DO
NOT REMOVE THIS COVER.
CAUTION: HOT SURFACE

Installation Instructions for Bottom-Mounted Devices

• Remove all objects from the cupboard and anything which is fragile
in the adjacent cupboards.
• For the installation the cupboard must fulfil the following conditions:
• Thickness of the cupboard floor between 16 mm and 19 mm
• Cupboard width at least 500 mm.
• The installation depth below the cupboard to the wall has to be
at least 320 mm.

NOTE:

If you would like the microwave to close with the front edge of
the door, an installation depth of 350 mm is necessary.
• The cupboard must not contain any cracks, splinters or other
damage. All connections must be stable.
• The cupboard must be designed for a minimum load of 40 kg.
• The wall mounting of the cupboard must be stable and anchored
firmly in the wall with at least 2 screws.

CAUTION:

Do not install the device above a cooker!
• When installing the device it must be ensured that there is a power
socket within reach.
• The mains socket must be within easy reach, so that the plug can
be quickly removed in an emergency.
• Important! Do not connect the device to the mains power supply
until after installation!
• The device cannot be installed under cupboards under which there
is a lighting strip.