Warning Information - MYERS Tire Supply 99080 Manuel Du Propriétaire

WARNING INFORMATION

This is the safety alert symbol It is used to alert you to potential
personal injury hazards Obey all safety messages that follow
this symbol to avoid possible injury or death
BEFORE USING THIS DEVICE, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING PROCEDURES, SAFETY WARNINGS AND
MAINTENANCE REQUIREMENTS
It is the responsibility of the owner to make sure all personnel read this manual prior to using the device It is also the responsibility of the device owner to keep this
manual intact and in a convenient location for all to see and read If the manual or product labels are lost or not legible, contact Myers Tire Supply for replacements
If the operator is not fluent in English, the product and safety instructions shall be read to and discussed with the operator in the operator's native language by the
purchaser/owner or his designee, making sure that the operator comprehends its contents
THE NATURE OF HAZARDOUS SITUATIONS
The use of portable automotive lifting devices is subject to certain hazards that cannot be prevented by mechanical means, but only by the exercise of intelligence,
care, and common sense It is therefore essential to have owners and personnel involved in the use and operation of the equipment who are careful, competent,
trained, and qualified in the safe operation of the equipment and its proper use Examples of hazards are dropping, tipping or slipping of loads caused primarily by
improperly securing loads, overloading, off-centered loads, use on other than hard level surfaces, and using equipment for a purpose for which it was not designed
METHODS TO AVOID HAZARDOUS SITUATIONS
• Read, study, understand and follow all instructions before operating this device.
• Inspect the jack before each use. Do not use jack if damaged, altered, modified, in poor condition, leaking hydraulic fluid, or
unstable due to loose or missing components. Make corrections before using.
• Lift only on areas of the vehicle as specified by the vehicle manufacturer.
• Wear eye protection that meets ANSI Z87.1 and OSHA standards (users and bystanders).
• Do not use jack beyond its rated capacity. Do not shock Load.
• This is a lifting device only. Immediately after lifting, support the vehicle with jack stands capable of sustaining the load
before working on the vehicle.
• Use only on a hard level surface free from obstructions so the jack is free to reposition itself during lifting and lowering operations.
• Center load on saddle. Be sure setup is stable before working on vehicle.
• Do not move or dolly the vehicle while on the jack.
• Do not use any materials that may serve as risers, spacers or extenders between the stock lifting saddle and the load.
• Do not use any adapters that replace the stock lifting saddle unless approved or supplied by the jack manufacturer.
• Do not use (or modify) this product for any other purpose than that for which it was designed without consulting the
manufacturer's authorized representative.
• Always lower the jack slowly and carefully.
• Failure to heed these warnings may result in serious or fatal personal injury and/or property damage.
WARNING: This product can expose you to chemicals including nickel which is known to the
State of California to cause cancer and birth defects or other reproductive harm. For more
information go to www.P65Warnings.ca.gov.
CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS
Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS, MAINTENANCE INSTRUCTIONS and
comply with them, and failure to comply with the METHODS TO AVOID HAZARDOUS SITUATIONS could cause accidents resulting in serious or fatal personal injury
and/or property damage
99080
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
2
WARNING: Indicates a hazardous situation
which, if not avoided, could result in death or
serious injury
Rev 1/22/21