Ninka Qanto R1 Instructions De Montage page 2

General assembly instructions
!
WARNING
• Anyone who performs connection or assembly work on Qanto must
have access to these assembly instructions. Follow these instructions.
Non-observance of the above mentioned instructions can lead to acci -
dents resulting in severe personal injury, such as trapped fingers and
electric shock.
• Assembly may be performed by expert personnel only, as incorrect
assembly may lead to injury or electric shock.
clearance from the edge of the counter, otherwise there is a risk of
injury.
• If the product is visibly damaged, it must not be installed, as a possible
malfunction may lead to injury or electric shock.
for the movement of the lifting system. When Qanto is extended upward
and to both sides, a clearance of about 7,87" (200 mm) to other cabinets
or shelving must be observed, otherwise there is a risk of injury.
• Make sure the cables are undamaged, as this may lead to electrical shock.
NOTICE
• The electrical system of Qanto must be accessible (e.g., a double so-
cket under the cabinet near the base).
!
CAUTION
• Before connecting the electrical drive to the in-house power mains,
on the type plate. The mains voltage and permissible input voltage must
be identical. If not, Qanto must not be connected.
• If the control unit causes unusual noises or odours during operation,
interrupt the power supply.
• A clearance of 11,82" (300 mm) must be observed between Qanto and a
gas stove, as heat may cause damage to the unit.
•
Select the length of the fastening screws for the bars in such a way that
they do not poke through the cabinet, otherwise the unit will be damaged
and this may lead to injury.
2
EN
Qanto_Id_A4_00000.50.065050_US