Meec tools 016362 Mode D'emploi page 35

WARNING!
The actual vibration and noise level when
using tools may differ from the specified
maximum value, depending on how the
tool is used and the material. It is therefore
necessary to determine which safety
precautions are required to protect the user,
based on an estimate of exposure in actual
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched off and when it is idling,
in addition to the start-up time).
DESCRIPTION
For wet cutting of tiles and clinker with a
diamond blade. The table can be angled for
mitring up to 45°.
1. Lock knob for guide rail
2. Parallel fence
3. Guide rail
4. Fence 45°
5. Clamps for parallel fence
6. Power switch
7. Scale on guide rail
8. Blade
9. Blade guard
10. Attachment for blade guard
11. Blade casing
12. Plug for water container
FIG. 1
ASSEMBLY
FITTING THE RUBBER FEET
1. Put the four rubber feet in the holes in the
base plate.
FIG. 2
FITTING THE BLADE
1. Remove the 45° fence.
FIG. 3
2. Remove the screw and washer from the
blade guard.
FIG. 4
3. Lift out the blade casing from its slot.
FIG. 5
4. Remove the blade nut and the outer
flange from the spindle.
FIG. 6
5. Put the blade on the spindle, fitted on the
inner flange. Put the outer flange on the
spindle.
FIG. 7
NOTE:
Check that the directional arrow on the blade
corresponds with the arrow on the casing.
6. Replace the blade nut. Two spanners
are included with the product. Lock the
spindle with one spanner and tighten the
blade nut with the other one.
FIG. 8
FITTING THE BLADE GUARD
1. Remove the screw and washer from the
attachment for the blade guard.
FIG. 9
2. Put the attachment for the blade guard
in the water container. The short leg of
the attachment should face the middle of
the table.
FIG. 10
3. Put the attachment for the blade guard
in the slot behind the blade on the back
edge of the table.
EN
35