Technical Data - Meec tools 016362 Mode D'emploi

EN
workpieces that are too small to be held
securely with your hands at a safe
distance from the blade.
• Make sure there is room for the cut-off
from the workpiece to move sideways.
Otherwise the cut-off can fasten against
the blade.
• Never cut more than one tile at once.
• Only the tile to be cut should be on the
table or near the table.
• Allow the motor to reach maximum speed
and the blade to rotate freely for a few
seconds before cutting.
• Switch off the tool immediately and pull
out the plug if the tool makes an
abnormal noise or the blade starts to
vibrate excessively.
• Switch off the tool, pull out the plug and
allow the blade and motor to come to a
complete standstill before removing any
material that has fastened or to clear
around the blade.
• Never touch the blade or other moving
parts during use.
• Switch off the tool and pull out the plug
before releasing the blade if it jams.
• Never attempt to remove splinters or
pieces before the blade has completely
stopped.
• Make sure that cut pieces are not thrown
up by the blade.
• Never leave the tool before the motor and
blade have completely stopped. Never
leave the tool unattended when it is
plugged in. Switch off the tool and pull
out the plug before leaving it.
• Use the requisite devices to move the tool.
Never lift or pull the tool with its guards.
Symbols
The following symbols can be of importance
for how you should use your power tool.
Make sure you understand the symbols
and their significance.
34
Read the instructions.
Approved in accordance with
the relevant directives.
Wear safety glasses.
Wear safety gloves.
Recycle discarded product
in accordance with local
regulations.

TECHNICAL DATA

Rated voltage
Output
Speed
Blade size
Cutting depth at 90°
Cutting depth at 45°
Cutting depth vid 22.5°
Table size
Size L390 x W365 x H165 mm
Weight
Sound pressure level, LpA 93 dB(A), K=3 dB(A))
Sound power level, LwA
Always use ear protection!
The declared values for vibration and noise, which
have been measured according to a standardised
test method, can be used to compare different
tools with each other and for a preliminary
assessment of exposure. The measurement
values have been determined in accordance
with EN 61029:2009.
230 V ~ 50 Hz
450 W
5200 rpm
Ø110 x Ø22.2 mm
Max 24 mm
Max 16 mm
Max 21 mm
365 x 390 mm
3.4 kg
108 dB(A), K=3 dB(A))