Cleaning And Maintenance - elem Garden Technic ASB3000-16 Traduction Des Instructions D'origine

USE OF THE LEAF BLOWER
Blowing setting
Inspect the work environment before you start work.
Remove objects or debris that could be thrown or
crushed or can get caught in the leaf vacuum / blower.
Use the selector lever the blower function and switch on
the device ..
Alternatively, you can also hold the tube output only
slightly above the ground and swing the machine from
side to side as you move forward and align the blowpipe
want to remove foliage. Inflate it to the appropriate pile
together and then use the suction to the foliage recite.
suction
Inspect the work environment before you start work.
Remove objects or debris that could be thrown or
crushed or can get caught in the leaf vacuum / blower.
Use the selector lever on the suction and switch on the
device ..
Alternatively, you can also hold the tube output only
slightly above the ground and swing the machine from
side to side as you move forward and align the intake
manifold was to be collected leaves. Do not press the
suction tube in the leaves into it, as this clogs the intake
manifold and the power of the engine is reduced.
Organic material such as Leaves have a high water
content, which may result in that they stick to the inside
of the pipe. To reduce this bonding, you should leave the
material to dry for several days..
Cleaning and Storage
Warning! Risk of injury by moving parts dangerous!
Ensure that all essential details, nuts, screws and brackets are
firmly attached and that all safety devices are firmly seated.
All damaged and worn parts should be replaced, and to preserve
the leaf vacuum / blower in a safe and good working order.
Never leave material in the leaf vacuum / blower or in the
waste-collection bag back. This could be dangerous the next
time the leaf vacuum / -gebläses.
After each use, the leaf vacuum / should be thoroughly cleaned
blowers.
Make sure that the leaf vacuum / blower off and unplugged.
Remove and empty the waste-collection bag. Make secure that
the blowing and suction mode selector lever can be moved
properly and is not obstructed by debris or other small items.
Remove loose-fitting dirt or small parts from the vicinity of the fan
and from the pipes.
Do not use cleaner on the plastic parts of the leaf vacuum /
-gebläses
INSTRUCTIONS FOR USE
_ Connect the appliance to a suitable extension cord.
_ Hold the appliance with both hands.
_ Slowly move the appliance back and forth.
_ Keep the wheels on the ground during use to reduce
the workload.
When operating, always hold the machine close to the
ground.
Do not blow hot, flammable or explosive material.
The garden vacuum is only suitable for foliage and
garden waste.
Please inspect the area for little animals and hard
objects before using the tool.
Do not vacuum liquids, plastic bags, cans, pine cones,
branches larger than 5 mm, cloth, tissues and pegs.

CLEANING AND MAINTENANCE

Check the blower vac for any signs of damage before
each use.
After using the machine
1. Empty the leaf bag.
2. Check the vacuum tube and remove leaf residue.
3. Check the blower vac's slide control for leaf residue.
4. Clean the machine with a soft dry cloth.
5. Store the machine in a safe place where it is out of the
reach of children.
If the device can not be started or continues to
malfunction, you need to check and repair the device by
a Service Centre.
Seite 18 von 36