Power Supply; Electrical Safety - elem Garden Technic ASB3000-16 Traduction Des Instructions D'origine

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Do not over reach and keep your balance at all
times.
Always be sure of your footing on slopes.
Walk, never run.
Keep all cooling air inlets clear of debris.
Never blow debris in the direction of bystanders.
Do not carry the machine by the cable.
The wearing of a face mask is recommended.
Do not modify this product. Unauthorized
modifications may impair the safety of your product and
may result in increased noise and vibration.
- Only use an extension cord weatherproof equipped
with a coupler according to
IEC 60320-2-3
- Always direct the cable to the back of the unit
- If a cable is damaged during use, disconnect the power
cord from the outlet area immediately.
DO NOT TOUCH THE POWER CORD BEFORE
DISCONNECT
- Operate the unit only in daylight or in good artificial
light.
- Replace worn or damaged parts.
- Only use spare parts and original accessories.
REMOVE THE PLUG FROM THE SOCKET:
– before checking, clearing a blockage or working
on the leaf blower/garden vacuum.
– after striking a foreign object, inspect the leaf
blower/garden vacuum for damage and make
repairs as necessary.
– if the leaf blower/garden vacuum starts to vibrate
abnormally check immediately.
- Before leaving the machine

POWER SUPPLY

The voltage indicated on the rating plate must
correspond
to the voltage of the power source.
We recommend that this equipment is only connected
into a socket which is protected by a circuit-breaker that
would be actuated by a 30 mA residual current.
Only use or replace power supply cables for this
unit which correspond to the types indicated by
the manufacturer. See the operating instructions
for the order no. and types.
Never touch the mains plug with wet hands.
Do not run over, crush or pull the power supply cable
or extension lead, otherwise it may be damaged.
Protect the cable from heat, oil and sharp edges.
The extension lead must have a cross section in
accordance with the operating instructions and be
protected against splashed water. The connection
must not be in water.

ELECTRICAL SAFETY

Motor Protector fitted! Motor fitted with safety
overload protection. If motor stops working, allow a
few minutes to cool, before restarting.
Warning! Switch off, remove plug from mains
before adjusting, cleaning or if cable is cut,
damaged or entangled.
Your machine is double insulated for safety and requires
no earth connection. The operating voltage is 230 V AC,
50 Hz (for non-EU countries 220 V, 240 V as applicable).
Only use approved extension cables. Contact the Centre
for details.
If you want to use an extension cable when operating
Seite 15 von 36

Publicité

Table des Matières
loading

Table des Matières