Hard Head 316414 Mode D'emploi page 6

ENGLISH
Read the User Instructions carefully before use.
• Variable adjusment
• All parts are rustproof.
• Made in Sweden
Bar of zinc-plated steel, cylinder of anodised aluminium, fitting of polyamide
•
Length 31-51 cm
•
The pack contains:
Holder
2 fasteners (one for inward and one for outward door)
4 screws
The balcony door holder should be placed on the upper frame and as shown in the diagram below
•
give an opening angle of 90°.
• To further restrict the opening angle: open the door to the required maximum position, pull out the
bar to its stop position and mark up the fixing holes.
Outward opening door/window
1. Use the fastener for an outward opening door.
2. Fit the door holder with the door closed.
Make holes with an awl.
1. Adjust the door holder friction with the set screw.
2. To fully open the door, release the pin by turning it and pulling it out from the fastener.
Inward opening door/window
1. Replace the fastener to an inward opening door.
2. Fit the door holder with the door closed.
Make holes with an awl.
1. Adjust the door holder friction with the set screw.
2. To fully open the door, release the pin by turning it and pulling it out from the fastener.
ENGLISH
DESCRIPTION
FITTING
6
Outward opening door/window
Inward opening door/window