Lock-Out Systems - SR Suntour AIR SPRING 700C NCX LITE CitySerie Mode D'emploi

SR SUNTOUR - OWNERS MANUAL
Cut the cable to a proper length. Approxi-
mately 12mm is recommended.
Install a cable end cap at the end of the
cut cable using a needle nose pliers.
If the fork does not lock, the tension of the
cable is probably too low. In this case you
have to increase the tension of the cable
by turning the adjustment barrel counter-
clockwise. If the cable's tension is too high
and the fork does not unlock, you have to
turn the adjust barrel clockwise.
LOCK-OUT SYSTEMS
The „Lock-Out" function of SR SUNTOUR forks is intended to reduce teetering during rides out of
saddle or uphill riding. The forks will not be locked 100%. A few millimeters of travel will remain,
according to our „Anti-Blow-Off-System". This system will protect you in case you have forgotten to
unlock the fork while riding in rough terrain.
Nevertheless, you should never set your fork to the „Lock-Out-Mode" while riding
in rough terrain, going down hill or jumping. This implies the risk that the fork will
get damaged when it's being compressed under high load. This could also result
into an accident, injuries or even death of the rider.
Never Lock your fork while it's being compressed. This is a missuse of your fork and
implies the risk that it's getting damaged. Moreover this could result into an acci-
dent, injuries or even death .
NRX S LOD / NRX S LO
NCX E LO LITE 700C
NCX E LO / NCX S LO 26"
CR-9 FT E LO / CR-9V E LO
In order to unlock your fork you
have to turn
10
Out" knob
English
the „Speed Lock
90° counter-clockwise.
NRX / NCX LITE / NCX / CR9
CUT
12mm
Adjustment
Barrel
90°