Programming Procedures; Initial Setup - Hiltron security XR500 Manuel De L'usager

XR500 - User's Manual
3

Programming Procedures

3.1

Initial Setup

Before you programming the central unit, be sure that the device is installed in position of
optimum reception.(par. 2.2)
Power on the XR500.
!
To enter in the programming mode, hold down for 5 seconds
!
"PROG" (Program) button up to listen a "BEEP".
If enabled, the system disables itself automatically; during all
programming procedures, the "ALLARME" (Alarm) LED
blinks quickly.
The "RETE" (Network) LED is lit to indicate one of 5 steps of
!
programming mode:
1. RF Channel Test.
2. Times Regulations.
3. Settings.
4. System Code management.
5. End of setup.
To move sequentially between the different steps of
!
programmng mode, press "STATO ZONE / MEMORIA
ALLARME" (Zone Status/Alarm Memory) button.
If no programming procedure is enabled over two minutes,
!
the XR500 utters a "BEEP" and exits automatically from the
programming mode without savings.
34
security