Cleaning And Care - Black & Decker IMPACT IR3000 Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3-way Auto Shut-Off
The iron will automatically switch to Auto Shut-Off mode and stop heating
after being left inactive for 30 seconds on the soleplate or side, and 8
minutes on the heel rest. When the iron is in Auto Shut-Off mode, the red
light on the handle will blink. Simply move the iron to resume ironing and
the soleplate will automatically heat to selected temperature.
Vertical Steaming
Iron can be used without an ironing board as a garment steamer by holding
with soleplate in a vertical position. Remove wrinkles from curtains, drapes,
and use for small touch-ups on fabrics suitable for steaming.
1.
Follow instructions 1-4 in "Using Your Iron" on page 5.
2.
Hang garment on a hanger in a location that would not be impacted
by the steam, such as a bathroom shower rod.
3.
With one hand, hold the garment tight from the base or side, being
careful to keep hands away from the steam. Hold preheated iron in
other hand.
4.
Place soleplate about an inch away from the fabric and press the
Burst of Steam button. Allow a few seconds between burst to avoid
water dripping.
Tip: If water dripping occurs, the iron isn't hot enough to create steam.
Simply allow the iron a minute to reheat and then resume steaming.
5.
When finished steaming, turn the Steam Selector to the Off/
Dry Iron setting and set the temperature control dial to the
minimum temperature setting. Unplug from the outlet.
6.
Stand iron on its heel rest and allow to completely cool
before storing.
CL E ANI NG AN D CA RE
This product contains no user serviceable parts. Refer to qualified service
personnel.
AUTO-CLEAN
SYSTEM
Use this feature to keep the iron free from build-up. For optimal performance
over time, clean the iron once every 2-4 weeks or more frequently with homes
having harder water.
1.
Fill the water tank well below the MAX fill line. Plug in the iron.
2.
Select the Linen fabric setting (number 6) on the temperature
control dial and stand the iron on its heel while it preheats.
3.
Allow the iron to heat to desired temperature for about 2 minutes,
then turn the Temperature dial to the minimum setting and unplug
from the outlet.
7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Impact ir3010

Table des Matières