Cleaning And Maintenance - Gaggenau CG 290 Instructions D'utilisation

Cleaning and maintenance:

Do not use washing powder,
oven-cleaning sprays or scourers
that might scratch the glass.
Never use sharp objects such as
metal scourers or knives to
remove the hardened remains of
food from the surface.
Never use a knife, scraper or
similar device to clean the area
where the glass meets the trim of
the burners or the decorative
metal frame.
Do not slide pans over the glass
because they could scratch it.
In addition, try not to drop heavy
or sharp objects on the glass.
Never strike any part of the
cooking hob.
Grains of sand that may come
from cleaning fruits and
vegetables will scratch the
glass surface.
Melted sugar and spilt foods that have a high sugar content should immediately be removed from the hotplate using
the glass scraper. After washing the pan supports, dry them well before using them to cook again - if there are
still any drops of water or damp patches left when you start
When cleaning the pan supports, be careful with the pegs, as they could come loose and scratch the glass or the
frame the next time you use the pan support.
9
DON'Ts
After each use, clean the surface
of the respective burner parts
once they are cold. If any bits
are left (overcooked food, drops
of grease etc.), however few they
will become stuck to the surface
and more
To keep the burners and pan
supports clean, you must clean
them periodically by placing them
in soapy weather and brushing
and with a non-metallic brush to
ensure that the holes and grooves
are perfectly clean, and can
provide a perfect flame.
Always dry the burner covers
and the pan supports if they
have become wet.
Use a glass scraper, and always
lay it flat to the glass, taking special
care not to get it too near to the
trim on the gas burners.
After finishing cleaning, dry all the
burner parts together with their
casing. The ring and the burner
cap must be inserted when placing
them on the burner casing.
Moisture and the incorrect
positioning of the respective
burner parts will affect the
uniformity of the flame generated.
cooking, they could damage the enamel.
DOs
difficult to remove later.