Adjustment Of Spring Tension - Jet AW3825 Guide D'utilisation

Adjustment of Spring Tension

1. Pull out approximately 6ft or 2m of hose and allow the drum to latch.
2. Remove hose stopper from hose, and feed hose back through guide.
3. Wrap the pulled hose one time around the drum to increase tension or un-wrap hose one time
from drum to decrease tension.
4. Re-insert hose through guide: and install stopper onto hose end.
5. unlatch the drum and check tension. Pull hose from reel and adjust stopper position
if necessary.
Replacement of Swivel Seal
1. turn off and disconnect supply line from swivel inlet.
2. Remove swivel assembly from reel axle.
3. Remove circlip from swivel, and take apart. Note: you may want to remove swivel from reel
hose end, but this is not necessary unless a new swivel is being installed.
4. Replace the seals and reassemble swivel.
5. use teflon tape or thread sealant on swivel thread fitting, reconnect the swivel thread fitting
with axle.
6. Re-connect inlet supply line.
Replacement of Hose
1. turn off supply to reel.
2. Pull out all the old hose and lock the reel in this position. Caution: Make sure reel drum is
securely locked and cannot rotate back.
3. Remove two hose clamps from hose.
4. Carefully disconnect hose from swivel joint on side of reel and remove old hose.
5. Feed hose through guide and opening in drum, and connect to swivel. Re-install two hose
clamps, on inside and outside of drum flange. Install stopper on other end of hose in the same
position as before.
6. Carefully release the drum latch, and slowly allow the hose to wind onto the reel.
Note: Final spring adjustment is accomplished by adding or removing wraps of hose around
the drum. (Refer to Spring tension adjustment)
Spring Canister Warning
If the rewind spring fails for any reason: For safety reasons, the manufacturer strongly
recommends the replacement of the spring canister be carried out by a qualified service depot.
4