Jet AW3825 Guide D'utilisation page 2

Prod. No. Mod. No.
391721 aW3825
391722 aW3850
391726 aW1250
391746 Oa1450
391741 HC100
391742 HC200
WARNING
Read the following precautions and instructions before you begin assembly or using. Failure to
comply with these instructions could result in personal injury or property damage.
Keep these instructions in a convenient location for future reference.
***NOTE: For model OA1450 see additional warnings on page 5
Hose Reel Safety Precautions
1. Make sure incoming line pressure does not exceed rated operating pressure
for your model hose reel.
2. use proper eye protection when assembling and using the hose reel.
3. assemble the hose reel on a clean workbench.
4. use soap and water when checking for leaks.
5. Keep children away from the work area.
6. exposure of skin directly to pressurized air, or fluid could result in severe bodily injury.
Installation of Reel
For overhead ceiling mounting: Install reels at least 10 feet above the floor. (If the reel you
have purchased does not have hose included, you will need to purchase and attach. Refer to
specifications on box to determine appropriate hose size and length. you will need to purchase
appropriate hardware for mounting your new reel.)
1. the reel base has four 1/2" (or 12.7 mm) drilled holes for mounting on a suitable flat surface.
Figure 2 is a template showing the correct location of the 4 mounting holes in the base.
2. the reel is supplied with a hose guide roller bracket. the bracket position may be changed
depending on the reel mounting position. Figure 1 shows "typical Mounting Positions." If
bracket position needs to be changed, do the following:
(a) Pull out some hose and let reel latch.
(b) Remove the bolts that attach the guide roller bracket to the support post.
(c) Rotate guide roller bracket to correct position, replace bolts and tighten.
3. using the four holes in the base, mount the reel in the desired location. Be sure to use
appropriate hardware and tighten securely.
4. apply teflon tape or pipe sealant to supply line threads, attach to reel inlet and tighten.
the other end of incoming line can now be connected to desired supply source.
5. If hose has been supplied with reel: apply teflon tape or pipe sealant to outlet fitting on reel
hose, then attach to desired tool, or nozzle.
6. Check connection for leakage, also check hose reel for correct operation.
(Refer to Operation Section.)
Description
air/Water
air/Water
air/Water
***Oxy-acetylene
air/Water
air/Water
Max.
capacity Pressure
3/8" x 25' 300
3/8" x 50' 300
1/2" x 50' 300
1/4" x 50' 300
3/8" x 100' 300
3/8" x 100' 300
2
Template (fig 2.)
PSI a
PSI B
PSI B
PSI C
PSI —
PSI —