Jet AW3825 Guide D'utilisation page 3

7. If hose stopper adjustment is required, pull hose from reel and allow to latch at desired
length. Loosen stopper bolts and slide stopper to a position close to the hose guide.
tighten stopper bolts, and unlatch the reel.
Installation of Hose
1. Securely stabilize the reel.
2. Facing the swivel fitting side of reel: turn the drum clockwise. by hand, until the rewind spring
is tight, and drum has latched. as an extra precaution while installing new hose, secure drum
in the latched position.
3. Insert end of the hose through guide roller bracket, and feed through opening in the drum
flange.
4. use teflon tape or pipe sealant on hose fitting threads, screw fitting into swivel and tighten.
Note: to avoid damage to the swivel, use a wrench to support the swivel fitting while tightening
the hose.
5. attach hose stopper on the other end of hose, near the outlet fitting.
6. Carefully release drum latch, and slowly allow hose to wind onto the reel.
Note: Final spring tension adjustment is accomplished by adding wraps of hose around the drum
(to increase tension) or taking off wraps of hose (to decrease tension).
Refer to: Adjustment of Spring Tension.
FIGURE 1
Operation
1. Check reel for correct operation by slowly pulling out the hose. a "clicking" noise will be heard
every half revolution of the drum.
2. to latch the reel, pull out the hose and allow it to retract after hearing the first second or
third "click"
3. to unlatch, slowly pull out the hose until the "clicking" noise stops, then let the hose retract
until the hose stop rests against the hose guide. Note: to avoid damage to the reel, always
hold on to the hose while it is rewinding.
4. Periodically check the hose condition for wear or damage, and check the swivel fitting for
leakage. Replace any worn, damaged, or leaking parts.
Wall Floor
3
Ceiling