Weston MH08 Serie Manuel D'instructions page 6

GRINDER ASSEMBLY INSTRUCTIONS
WARNING
w
reach into grinder feed chute. Always use stomper. Never operate without tray in
place. Secure long hair and loose clothing before use. Disconnect power before
assembling. Always read instructions.
1. Make sure Meat Grinder is
unplugged. Insert the Head into the
Gear Housing with the Feed Chute
facing straight up. You will need to
line up the slot in the Head with the
Key inside the Gear Housing. Be
sure the Head is seated fully into the
Gear Housing (FIGURE 1).
2. Tighten the Head-Locking Knob
to lock the Head into place.
3. Insert the Auger, with the Auger
Bearing attached, into the Head
(FIGURE 2). Align the Auger Splines
with the Drive Shaft of the Grinder.
NOTE: Periodically inspect the
Auger Bearing for wear. If the Auger
Bearing has excessive wear, replace
it to prevent head damage.
4. Place the Knife onto the square
part of the Auger Pin (FIGURE 2).
Be sure the blades of the Knife
are facing outward.
5. Place one of the Grinder Plates onto
the Auger Pin; align the notch in the
Grinder Plate along with the Pin in
the Grinder Head.
6. Install the Front Ring Nut. DO NOT
OVERTIGHTEN. Turn the Front
Ring Nut until it makes contact with
the grinder plate; then make 1/4 turn
more to tighten into place.
7. Insert the neck of the Tray into the
Feed Chute (FIGURE 3). Plug into
electrical outlet.
8. NEVER operate Grinder without the
Tray secured in place (FIGURE 3).
6
840303701 v15.indd 6
Entanglement Hazard. To avoid serious or fatal injury, never
Slot in Head
Feed
Chute
Head
Drive Shaft
Gear
Housing
Auger Bearing
Auger Splines
Auger
Auger Pin
Knife
Grinder Plate
Front Ring
Nut
NOTE! Be sure the blades
of the Knife are facing out.
Tray
Neck
Feed
Chute
Head
FIGURE 1
Head-Locking
Knob
FIGURE 2
Head
FIGURE 3
Tray Support
Bracket (#22 &
#32 models only)
2/21/20 10:26 AM