Weston MH08 Serie Manuel D'instructions page 10

HIGH-SPEED STUFFER ASSEMBLY INSTRUCTIONS
WARNING
w
into grinder feed chute. Always use stomper. Never operate without tray in place.
Secure long hair and loose clothing before use. Disconnect power before assembling.
Always read instructions.
NOTE: The High-Speed Stuffing System
is designed for use with the 10-mm
Funnel ONLY. DO NOT attempt to use
the High-Speed Plastic Auger with any
other Funnels. SERIOUS DAMAGE to
the Grinder Head and other components
may occur. Follow the "Standard Stuffer
Assembly Instructions" located in this
manual, when using the 20-mm, 30-mm,
or 40-mm Funnels.
1. Make sure Meat Grinder is unplugged.
Insert the Head into the Gear Housing
with the feed chute of the Head facing
straight up. You will need to line up the
slot in the Head with the Key inside
the Gear Housing. Be sure the Head
is seated fully into the Gear Housing
(FIGURE 8).
2. Tighten the Head-Locking Knob to lock
the Head into place.
3. Insert the Auger, with the Auger Bearing
attached, into the Head (FIGURE 9).
Align the Auger Splines with the Drive
Shaft of the Grinder.
NOTE: Periodically inspect the
Auger Bearing for wear. If the
Auger Bearing has excessive wear,
replace it to prevent head damage.
4. Slide the High-Speed Plastic Auger onto
the Auger Pin, making sure the square
part of the Plastic Auger fully seats on to
the square portion of the Auger Pin.
5. Slide the 10-mm Stuffing Funnel
through the Flange and place it
through the Front Ring Nut.
6. Install the Front Ring Nut. DO NOT
OVERTIGHTEN. Turn the Front Ring
Nut until it makes contact with the
Flange; then make 1/4 turn more to
tighten into place.
7. Insert the neck of the Tray into the Feed
Chute (FIGURE 10). Plug into electrical
outlet.
8. NEVER operate Grinder without the
Tray secured in place (FIGURE 10).
10
840303701 v15.indd 10
Entanglement Hazard. To avoid serious or fatal injury, never reach
Slot in Head
Feed
Chute
Head
Drive
Shaft
Gear
Housing
Auger Bearing
Auger Splines
Auger
Auger Pin
10 mm
High-Speed
Stuffing Funnel
Flange
Front Ring
Nut
Tray
Neck
Feed
Chute
Head
FIGURE 8
Head-Locking
Knob
FIGURE 9
Head
High-Speed
Plastic Auger
FIGURE 10
Tray Support
Bracket
(#22 & #32
models only)
2/21/20 10:26 AM