Emc-1 Status Leds; Ethernet Write Led; Connectivity; Msview - Morningstar EMC-1 Manuel D'installation Et D'utilisation

EMC-1 START-UP SEQUENCE (with MS device connected)
Status LED flash
LEDs ON for 3 secs
With the EMC-1 powered, and the RJ-45 cable
connected, RJ-45 LEDs will light as indicated in the
table below.
ETHERNET JACK INDICATIONS
Condition
Network Connection OK
Network Activity
Error
3.3 EMC-1 Status LEDs (green and red)
Flashing green: 1 every sec -
may not appear if MS Device
is found quickly
Solid green (heartbeat off)
G-G-G....R-G-G-G...
(repeating)
Flashing red - green:
1 every sec
Flashing green:
3 every sec
Flashing red: 1 every 2 secs
G
G + G + (G)
Yellow
Green LED
LED
ON OFF
ON Blinking
OFF ON
Searching for Morningstar
Device
Morningstar Device found,
communicating
No valid Morningstar Devices
found
Morningstar Device found,
unkown device ID - update
EMC-1 firmware
Firmware upgrade or downgrade
in progress. Power should not
be removed while in this state.
Internal fault condition
11
3.4 (Future Use) Web Service DIP Settings and
LED
(green / red) Indications
TBD
TBD
TBD
TBD
TBD
TBD
TBD
* Log-in and/or server registration error

3.5 Ethernet Write LED

DIP 1 OFF (green OFF)
DIP 1 ON (green ON)

3.6 Connectivity

3.6.1 MSView

MSView is a Morningstar software utility that allows
real-time system data interface with a PC, the
capability to custom program charging parameters,
and data logging. MSView is available for download,
at no charge: www.morningstarcorp.com/msview/
For complete connection details, see the Product
Connectivity Manual, available on our website:
www.morningstarcorp.com/wp-content/up-
loads/2014/02/
Broadcasts disabled
Broadcasts enabled
Searching for server /
establishing connection
Connection made / broadcasting
Cannot connect to server
TBD
Invalid log-in credentials*
(connected to server)
(green)
Ethernet writes disabled
Ethernet writes enabled
12