Features; Installation; Mounting - Morningstar EMC-1 Manuel D'installation Et D'utilisation

1.2 Features

The features of the EMC-1 are shown in Figure 1-1
below. An explanation of each feature follows.
1
Figure 1-1 EMC-1 Features
1 - DIP Switches
DIP 1 enables Ethernet write commands
DIP 2 enables Web Monitoring Service (future use)
2 - Reset Button
Used for factory reset or firmware failure
3 - Ethernet port (RJ-45)
Used to connect the EMC-1 to LAN / Internet
4 - Power Input
8-80 Vdc power input
5 - Status LED
Green and red lights indicate unit status
6 - Web Monitoring Service LED
Green and red LEDs indicate Web Service status
7 - Ethernet Write LED
Green light indicates Ethernet write command capability
8 - Meterbus (RJ-11 port)
Used to connect the EMC-1 to Morningstar Device
9 - DIN rail mounts (bottom of unit)
35mm standard size
5 5 6 7
3

2.0 INSTALLATION

2.1 Mounting

The EMC-1 can be wall-mounted, surface-mounted or
DIN rail mounted using basic tools:
Flat head screw driver
Philips head screw driver
Drill (if wall or surface mounting)
1/8" drill bit (if wall or surface mounting)
Option 1 - Wall and Surface Mounting:
Step 1
Locate the EMC-1 on a surface that is protected from
direct sun, high temperatures, corrosive fumes, and water.
Do not install in a confined area where battery gases can
accumulate.
Step 2
Before starting the installation, place the EMC-1 on the
surface where it will be mounted and determine where the
wires will enter and exit. Be sure there is sufficient bending
room for the wires and communication cables. If possible,
verify that the mounting screws will not penetrate wires or
other objects located on the opposite side of the surface.
Step 3
Place the EMC-1 on the intended mounting surface, mark
four holes for drilling. Remove the EMC-1 from the
surface, and using a 1/8" bit, drill pilot holes for each of
the four mounting screws, as indicated on the surface.
4