Installation
9) Place mounting plate (M) in po-
sition, mark and drill 3/16" holes
for tile anchors (M1), 5/16" holes
for drywall anchors (M2). Install
anchors.
M1
M2
M
Note: For dry wall 1/2" thick or less,
insert anchor tool (M3) into drywall
anchor (M2) to secure behind wall
prior to installing wall cradle.
Operation (Temperature Control)
1) Turn shower handle counterclock-
wise approximately 1/4 turn to put
valve in cold position.
Operation (Diverter Control)
1) Cartridge is factory set to divert
to function 1.
10) Remove cover of hand shower
cradle (N). Install cradle and
mounting plate (M). Secure with
three screws (O). Replace cover
on hand shower cradle.
O
M2
M3
2) Turn shower handle counterclock-
wise approximately 1/2 turn to put
valve in warm position.
2) Turn handle to position 2 to divert
to function 2.
11) Attach hand shower (L) to hose (S).
N
M
3) Turn shower handle counterclock-
3) Turn handle to position 3 to share
Note: In this position there is no detent.
5
Attach hose (S) to vacuum breaker
(R). Connect vacuum breaker (R)
to wall ell (P). Turn clockwise to
tighten.
L
R
S
S
wise approximately 3/4 turn to put
valve in hot position.
functions 1 and 2.
P