Electrical Connection; Installing - AGA marvel ML15WSG2 Serie Instructions D'installation, D'utilisation Et D'entretien

Celliers

Masquer les pouces

Table des Matières

Les langues disponibles

avoid scratching the floor. With the assistance of

another person, lean the appliance back to access the

front leveling legs. Raise or lower the legs to the

required dimension by turning the legs. Repeat this

process for the rear by tilting the appliance forward

using caution. On a level surface check the appliance

for levelness and adjust accordingly.

The front grille screws may be loosened and the grille

adjusted to the desired height. When adjustment is

complete tighten the two front grille screws. (See Figure

5).

Figure 3

• Do not use an adapter. See Figure 4).

• Do not splash or spray water from a hose on the appliance. Doing so may cause an electrical

dance with the National Electrical Code and applicable local codes and ordinances (see Figure 6). If the

circuit does not have a grounding type receptacle, it is the responsibility and obligation of the customer to

provide the proper power supply. The third ground prong should not, under any circumstances, be cut or

removed.

INSTALLING YOUR APPLIANCE

Electrical Shock Hazard

Do not remove • Do not use an extension cord with this appliance. ground prong They can be

•

This appliance should not, under any circumstances, be installed to an un-

grounded electrical supply.

•

Do not remove the grounding prong from the power

shock, which may result in severe injury or death.

A grounded 115 volt, 15 amp dedicated circuit is required.

This product is factory equipped with a power supply cord that has a

three-pronged, grounded plug. It must be

Figure 4

Model

Door Style

ML(15)(24)*

(S) or (G)

ML(15)(24)*

(P) or (F)

hazardous and can degrade product

performance.

cord. (See Figure 3).