Goelst 6000 Serie Manuel page 13

Removing ALL RF channels (individual channels cannot be removed)
!
Removing all RF channels is also a timed procedure: Please read all steps before proceeding.
B A
Programming curtain positions
!
Provisional end-postions are factory-set at 40 cm running distance.
Programming of the "Curtain opened" and "Curtain closed" positions is now required for
systems 6200, 6200-T, 6500, 6500-T or 6700, where the 'pre-fix' shown on the silver motor
identification label is "20", "2T" or "5T". This must be carried out per system. Once these start
20/D785/110107
S.W. 4.3 24Vdc , 1,8Amp
M a d e i n N L
curtain rail systems
1) First remove all power plugs and data leads from the motor units of systems already con-
nected - as well as all other systems within reach of the RF transmitter (35 metres indoors).
Connect an RF receiver to the motor unit and ensure an RF channel is set in the receiver (see
2T/A94A/115870743
!
above). End positions can be set only with previously set RF channels. Connect power supply
Tandem Partner ID: 2T/A94B/11587077
S.W. 4.3 24Vdc , 1,8Amp
to the motor
M a d e i n N L
curtain rail systems
2) If during the following proceedure no operating instructions have been transmitted (within
1 minute), the motor unit will automatically exit programming mode: the motor unit LED will
go out, return to step 1.
30/A9B5/11587074K
S.W. 4.3 24Vdc , 1,8Amp
M a d e i n N L
curtain rail systems
STEP 1
Press and hold button (A) on the receiver.
STEP 2
With the button (A) pressed, the LED (B) will light up, then goes out and
then flashes 3 times.
STEP 3
Release button (A) exactly during the third flash. The LED will flash 5
times to confirm that ALL channels have been removed.
and stop positions have been set, the system will always operate
within these two limits. The end positions can be fine-tuned during
programming for a smooth curtain folding effect.
(6200, 6200-T, 6500, 6500-T and 6700)

NL EN DE FR