Goelst 6000 Serie Manuel page 12

Masquer les pouces Voir aussi pour 6000 Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles


NL EN
DE
FR
Antenna
Setting RF-channels
Before operation of the electric curtain rail is possible, first the RF-channels have to be set. The
2 steps below must be followd for every motor.
!
Setting the RF channels is a timed procedure requiring each step has to be executed within a
certain time. Please read all steps carefully before staring this procedure.
WM001C
WM003C
B
A
WM001G
WM002G
WM003C1G
WM006G
2
!
Following the procedure above, further channels can be added later – up to 85 channels
in total.
In the event of poor transmission signal, the antenna, which is
concealed within the receiver housing, can be extended outside of
the housing as follows:
With the aid of a flat screw driver, open the housing at the points
indicated in fig 3.
The white wire is the antenna: straighten it
3
carefully and lead it through the small cut-out
in the housing (fig.4).
Do not cut the antenna!
Ensure the circuit board is correctly replaced in position between
the notches, then replace the lid by pressing firmly. (fig.5)
5
WM003C
WM009C
STEP 1 - Receiver unit
WM009C
EN
Press button (A) on the receiver and hold for 3 seconds.
IT
Release the button when LED (B) lights.
FR
ES
STEP 2 - Transmitter unit
DE
Within 10 seconds, press the STOP button of the desired channel until the
PL
WM002G
WM003G
NL
LED on the receiver goes out and flashes 3 times to confirm.
WM003G
On a 6- or 80-channel transmitter, choose a channel first and then press
the stop button.
WM080G
To add more channels repeat STEP 2 while the LED is still lit (within 10
WM006G
WM004G
WM004G
seconds) by selecting the desired channel on the transmitter.
If no further signal is received from the transmitter, the receiver
automatically exits the channel programming mode after 10 seconds.
The receiver and transmitter should now be ready to use.
EN
Range of NiceWay transmitter modules
Range of NiceWay transmitter modules
IT
Gamma dei moduli-trasmettitore NiceWay
Gamma dei moduli-trasmettitore NiceWay
FR
Gamme des modules-émetteur NiceWay
Gamme des modules-émetteur NiceWay
ES
Gama de los módulos-transmisores NiceWay
Gama de los módulos-transmisores NiceWay
DE
Die Reihe der NiceWay Sendermodule
Die Reihe der NiceWay Sendermodule
PL
Gama modułów-nadajników NiceWay
Gama modułów-nadajników NiceWay
NL
Assortiment zendmodules NiceWay
Assortiment zendmodules NiceWay
WM080G
A B
C D
4
WM240C
WM240C
A B
C D
A B
C D
A B
C D

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

6045-2200

Table des Matières