Brandson Equipment 303228/20180122NT002 Manuel D'utilisation page 33

4. Commissioning
Take the device out of the package and remove all the packaging materi-
al. Check the scope of delivery for completeness. Charge the battery fully
using the charger provided. Insert the desired screwer or drill bit into the
quick release chuck and fix it.
Insert the charged battery at the bottom of the device into the port and
make sure that it locks into place.
When using the device, keep one hand on the handle and the other
hand at the bottom of the battery, so as to be better able to control the
rotary action. Set the desired torque for your work using the rotating
ring. Finally, set the desired direction of rotation. The device is now
ready for use.
Note: If the speed reduces too much, then always reduce the load or stop
using the device to avoid damage.
5. Usage - Screwer mode
Position the tip of the screwer insert at the appropriate place and apply
pressure to the tool. Let the device start running slowly and gradually
increase the speed. Release the "On/Off"button as soon as you reach
the torque limit.
5.1 Usage - Driller mode
Rotate the torque adjustment ring to the drill symbol.
33
English