Panasonic WV-CW384E Manuel D'utilisation page 17

<Fine adjustment of the back focus through the setup menu>
1. Loosen the 1 fixing screw of the rear cover to remove the rear cover.
2. Loosen the 2 fixing screws of the switch cover to remove the switch cover.
3. Hold down the setting button for 2 seconds or more to call up the top screen of the setup menu. And then adjust the
back focus. For further information, refer to page 31.
Rear cover
m
Mount the cover
1. Attach the desiccant (accessory) to the inner bottom side of the lens cover.
2. Mount the lens cover, switch cover, and rear cover.
Mouning lens cover
(3)
(2)
Fixing screw x4
Important:
• The tightening torque described below shall be followed for the 2 fixing screws of switch cover and the 4 fixing screws of
lens cover.
Recommended tightening torque: 0.59 N·m
• Be sure to attach the desiccant (accessory). Refer to the instructions for the desiccant for how to attach it.
• The tightening sequence of the 4 fixing screws of the lens cover shall be observed and repeated twice as described in the
illustration above.
((1) → (2) → (3) → (4), twice)
Fixing screw x1 Switch cover
Mouning switch cover
(1)
(4)
Switch cover
Fixing screw x2
Mouning rear cover
Rear cover
Fixing screw x2
Set button
Fixing screw x1
17