Installation (B): Antenna, Piggy-Back Ex Factory - SMA BEAMPB-NR Mode D'emploi

SMA Solar Technology AG

1.1.3 Installation (B): Antenna, Piggy-Back ex Factory

If the Radio Pigy-Back has already been installed at the factory, the antenna can be fastened to the
inverter as follows.
1. Remove the protective cap from the thread of the antenna on the
inverter housing.
2. Plug the sealing on the thread of the
antenna on the inverter housing.
3. Screw the antenna tip to the thread of the
antenna on the inverter housing.
Installing a Radio Piggy-Back in an Inverter
BEAMPBNR-BXX072623 15