Notes On Installation In Swr Inverters - SMA BEAMPB-NR Mode D'emploi

Installing a Radio Piggy-Back in an Inverter
4. Insert the end of the antenna cable through the
PG opening on the inverter housing.
5. Tighten the PG screw fitting from the interior of
the housing with the grooved ring. Make sure
that you tighten the grooved ring so tightly that
the paint on the enclosure is damaged and thus
contact is made with the bare metal of the
inverter enclosure.
6. Screw the antenna cable to the antenna
connection of the Radio Piggy-Back (see figure at right).
7. Lay the antenna cable as described in the inverter
documentation.
8. Do not mount any jumpers on the inverter.
9. Close the inverter as described in the inverter
documentation.

1.1.2 Notes on Installation in SWR Inverters

Implementation of the Radio Piggy-Back with SWR 1500 and SWR 2000 requires
installation of an intermediate adapter (SMA order number: SBEAMPB-ISO-NR).
For safe use of the Radio Piggy-Back in all inverters of type "SWR", the resistors (if present) attached
to the circuit board at the provided Piggy-Back plug-in position must be removed.
Resistors
14 BEAMPBNR-BXX072623
SMA Solar Technology AG
grooved ring
Antenna connection