RIKA GSM RIKATRONIC4 Notice D'utilisation page 29

12. OPERATION
Save your telephone-number (done only once)
The operation of the stove is controlled by SMS commands. These consist of the code you selected (described
earlier) and a command. After correct installation of the GSM set you must save a valid telephone number on
the device. This is not possible when you suppress your telephone number. Further informations for activation
of the number can be found in the operating instructions of your mobile phone.
In this case the TEL command follows the code.
1234 TEL
(Note the SPACE between code and
command)
Now the SMS-commands will be processed correctly.
Note
You are also able to save a new number by sending a TEL code again.
You also can send commands without registering a telephone number using simply the reception code. In this
case you will get back a message „Please save TEL. number" in your answer-SMS.
Note
If no telephone number is stored at the device you will not receive any message in case of errors.
Command input:
You can now control your stove via SMS. Please bear in mind however that the stove can only be ignited if you
have previously placed lighters in the ignition support and provided chipboard and logs. The stove will cool off
after combustion unless it is reloaded.
Example SMS
1234 ON (Note
the SPACE between
reception and
command code)
1234 A1200
1234 AOFF
1234 T1657
Tipp
for the commands: case insensitivity!
Note
Please note that at the time of automatic ignition, a sufficient chimney draft must be ensured. In a multiple
use of the chimney, an automatic ignition with the Rikatronic4 may only be carried out under the supervision
of the operator.
The device will save the telephone number and send a
confirmation message back.
MOBILE NUMBER „your number" – OK
Function
Switching on ignition
Switching to auto mode with pre-set
time (example: 12 o'clock)
enter time without colon!
Cancelling auto mode after using pre-set
time.
Saving pre-set time to the stove
enter time without colon!
Reply-SMS
STOVE ON IGNIT
Stove igniting
AUTOMATIC SET TO 12:00
Time displayed.
AUTOMATIC OFF
Stove in idle state.
CLOCK SYNCHRONIZATION – OK
Time saved successfully.
|29
28