RIKA GSM RIKATRONIC4 Notice D'utilisation page 28

2x N111835
hexagonal screw
After finishing the work mount the parts again and reconnect the power supply.
11. ACTIVATION
To activate the GSM function, the GSM setting must
be set to ON under the SETUP / Settings menu. The
four-digit receive code needs to be set up.
In order to activate the stove's GSM function, press
the function key to enter the setup menu. Then use
the menu key to click through until you reach the
menu item GSM.
GSM
OFF
ON/OFF
WAIT
FAILED
OK
1XXX
12XX
123X
1234
Access the GSM submenu using the function key.
Press the plus or the minus key to switch to ON
and confirm with the menu key. (OFF deactivates
the GSM function and switches the display back to
setup menu.) The display reads WAIT while the stove
initialises.
If the initialisation was unsuccessful, the display
briefly signals FAILED on red. Check your connections
and start again.
Now you can set the code. Set the digits using the
plus and the minus keys; confirm each using the
menu key.
You can select this code free. (On the following pages
the numbers 1234 are used by way of example to
make the instructions comprehensible.)
The code is used to prevent unauthorised access to
your GSM Modem.
According to a successfully command code a
confirmation message will be sent. This is not
possible when you suppress your telephone number!
Important
To get answer messages enough credits on the
SIM-card are necessary.
Note:
When the GSM has been properly connected to the
stove's interface and the plug has been inserted into
the power socket, the LED display on the modem will
flash orange at brief intervals. If there is adequate
reception, the orange display will flash at long
intervals.