Safety Notes - Astral SUPER SPRINT Notice De Montage Et De Mise En Service

ENGLISH
1 General
Installation and service by qualified personnel
only!
1.1 Applications
The pool circulating pumps are used in conjunc-
tions with highrate sand filter plants for private
1.2 Technical data
1.2.1Performance and electrical data (Table 1)
Max. permissible pressure
Main voltages
Speed
Capacity and current
Flow rate and -heat
Protective system
Haupt- und Anschlußmaße, Tabelle 2
Types
0,6 KW
0,7 KW
0,95 KW + 1,5 KW
Resistance to chemicals are limited by the follo-
wing limits:
– Max. water temperature: 40°C
– pH-value: min. 6, max. 7,8
– Free chlorine: 0.2 up to max. 2.0 mg/l (or ppm),
Short term limit e.g. for reconditioning of pool
water max. 20 ppm.
– Free chlorides: max. 250 mg/l
– The pump is not suitable to handle sea or salt
water
– Pump must not be used to handle water condi-
tioned by Sodium Hypochlorit (by electrolysis).
– Pump must not run dry.

2 Safety Notes

These instructions contain basic reference which
must be strictly adhered to. It is therefore impera-
tive for the installer and the Operator to carefully
read these instructions prior to installation and
commissioning.
8
DA DI
– 50
– 50
63 –
swimming pools. They are resistant to chemicals
normally used for pool maintenance, but not to sea
or salt water.
1 Ù 230 V ± 10 % , 50 Hz
3 Ù 400 V ± 10 % , 50 Hz
see rating plate
see rating plate
see rating plate
dimensions [mm]
h
366
366
400
Please observe, not only the safty directions under
the main heading SAFTY RULES, but also those
added and specially marked under the ensuing he-
aders.
2.1 Safty marks contained in these instructions
Safaty references contained here in which, if not
complied with, may cause death or severe perso-
nal injury from electrical causes are specially high-
lighted by the following danger symbol:
Safty refernces which, if not complied with, may re-
sult in damage to the plant or its function are high-
lighted by the word:
2,3 bar
IP 54
l1 l2
265 525
265 560
300 595
ATTENTION!