Appliance Description; Before First Use; Preparing Coffee - Inventum PK502 Mode D'emploi

2

appliance description

1. Coffee­outlet
2. Lid
3. Water reservoir
4. Button for 1 cup of coffee ­
5. Button for 2 cups of coffee ­
6. Button for MANUAL ­
7. On/off button
8. Safety pin
9. Lever for lid
10. Padholder
11. Anti­slip mat
12. Grid
13. Driptray
14. Coffeepadholder 1 pad
15. Coffeepadholder 2 pads
3
before the first use
Before you use the appliance for the first time, please do as
follows: Carefully unpack the appliance and the accessories
and remove all the packaging material. Keep the material
(plastic bags and cardboard) out of reach of children. Check
the appliance after unpacking for any visible damage, possible
from transportation. Place the appliance on a stable and heat
resistant surface.
Clean both coffeepadholders, the driptray, the grid, the anti­slip
mat and the coffee­outlet mixer with warm soapy water. Dry the
parts thoroughly. Make sure that the parts are completely dry.
Wipe the exterior with a soft damp cloth and dry thoroughly. The
appliance is only suitable for preparing warm drinks with soft
pads. Never fill the water reservoir with other fluids than water.
Rinse the coffeepadmachine for the first use 2­3 times with
clean water.
Slide the driptray onto the bottom of the coffeepadmachine.
When not in place, slide the coffee­outlet in the opening on the
front of the coffeepadmachine. Carefully pull the reservoir by
the handle from the coffeepadmachine. Fill the reservoir to the
maximum indication. Replace the water reservoir. Check that
the voltage in your home corresponds with the voltage printed
on the bottom of the appliance and plug the appliance in.
10
• English
1 1
2
3
4
5
6
7
4

preparing coffee

Press the ON/OFF button. The control light will blink, indicating
the water is heating. As soon as the control light is constantly lit,
the coffeepadmachine is ready for preparing coffee.
Press on the lid with your thumb and open the lever for the
lid with your finger. The lid is now unlocked and opens. Place
the correct coffeepadholder for 1 or 2 coffeepads, depending
of the number of cups you want to prepare. Place the right
amount of coffeepads in the padholder ­ one coffeepad for
the coffeepadholder for 1 coffeepad or two coffeepads in the
coffeepadholder for 2 coffeepads.
Close the lid by pressing it down firmly. You should hear a 'click'
and the safety pin should lower. If you don't hear the click, check
whether the coffeepadholder is placed correctly.
Place one or two coffeecups on the grid under the coffee­
outlet. Press the button corresponding the number of cups you
want to make, 1 or 2 CUPS or press the button for MANUAL.
When using the button MANUAL you must stop the water flow
yourself by pressing the button MANUAL again when your cup
is filled with the desired amount of coffee. If you don't, the cup
will overflow.
You can turn the coffeepadmachine off yourself by pressing the
ON/OFF button. If you don't, the coffeepadmachine will turn
itself off after 10 minutes to save energy.
8
9
10
11
12
13
14
15