Regalo 1350 Instructions De Montage page 3

Option A: Installing Your Gate Between Two Walls
STEP 1
LOCKING KNOB
Unfold the gate frame by turning the locking
knobs counter clockwise at each pivoting
joint. Loosen the knobs enough to allow the
gate to swing open freely without fully
removing the knobs.
Option B: Installing Your Gate as a Play Yard
STEP 1
LOCKING KNOB (2)
TOOTHED DISK (2)
WALL MOUNT BOTTOM CAP − MALE (1)
WALL MOUNT BRACKET (2)
Unfold the gate frame by turning the locking knobs counter clockwise at each pivoting joint. Loosen the knobs enough to allow the gate to swing open
freely without fully removing the knobs. Release the vertical metal pivot bars at each end of the play yard by removing the following parts from the
assembly.
STEP 2
Use a Phillips/crosshead screwdriver to fix the
wall mounting bracket (B) to the wall. Repeat
for all four brackets.
METAL PIVOT BAR (2)
STEP 3
51-1/2" Minimum Width
Arrange the panels to your desired configuration,
then tighten all of the locking knobs.
NOTE:
This gate is designed to fit openings
50.5 inches (128.27cm) to 192 inches
(487.68).
WALL MOUNT TOOTHED DISK (1)
WALL MOUNT BOTTOM CAP − FEMALE (1)