AL-KO BKS 2625 T Traduction Du Mode D'emploi D'origine page 52

en
91P
E1-25
Depth gauge setting
Maintenance of the bar (25)
The bar should be turned around regularly in order
to prevent asymmetrical wear. The following are
required to retain the efficiency of the bar:
Lubricate the bearings of the reversing spro-
cket using the corresponding spray (if avail-
able).
Clean the groove of the bar using the appro-
priate scraper (not included in the scope of
delivery).
Clean the lubricating holes.
Use a flat file to remove burrs from the guide
flanks and compensate for any deviations
between the guides.
The bar must be renewed if:
The depth of the groove is less than the
height of the pulling link (which is never allo-
wed to touch the base of the groove);
The inner guide wall is worn to such an extent
that the chain tilts to the side.
Work that does not form part of the usual
procedures
Any maintenance work not described in this ma-
nual is only allowed to be performed by your dea-
ler.
Work that is not carried out by a specialist orga-
nisation or is performed by unqualified personnel
will invalidate the warranty in all cases.
52
5/32" 30°
5/32" 30°
0°
0°
Storage
After working, clean the machine carefully and
remove dust and residues, and repair damaged
parts or renew them. The machine must be kept
in a dry place, protected against the weather and
with the chain guard fitted properly.
Lengthy downtimes
If the machine is not expected to be used for 2-3
months, perform the following tasks so as to avoid
difficulties or permanent engine damage when ta-
king it back into operation.
Storage
Before the machine is taken out of service:
Clean the chain saw and service it before sto-
ring it.
Unscrew the nut, remove the cover and take
off the chain and bar.
Empty the oil tank, fill approx. 100-120 cc of
specific cleaning fluid and put the cap back
on.
Mount the cover again without tightening the
nut, ensuring that the two rear fasteners are
correctly seated.
Start the machine and run the engine at high
speed until all of the cleaning fluid has been
consumed.
BKS 2625 T / BKS 2625 TSB
Maintenance and storage
80° 0.025"
85° 0.025"
File