Switching Off; Additional Functions; Adjusting The Water Softener - Porter & Charles DW18PCFI Manuel D'utilisation

USER INSTRUCTIONS
2.2.8

Switching off

At the end of the program, the dishwasher emits a short beep and the indica-
tor lights of the fourth and fi fth program (ref. pr. 4, pr. 5 fi g. 2-04) fl ash.
Turn off the appliance by opening the door and pressing the on/off button (ref.
1 fi g. 2-02).
2.3

Additional functions

2.3.1

Adjusting the water softener

N.B.: a different washing program from soak must be used to make
the following adjustment. .
Press and hold down the program delay button (ref. 7 fi g. 2-05) until the pre-
set value appears followed by a dot (normally 3.). Release the button and then
press it again and again until the required value is displayed, as indicated in the
table (see tab. 2-03).
The 6 possible adjustment levels will appear in this sequence:
3., 4., 5., 0., 1., 2..
When the required value appears on the display, release the button; after 5
seconds the appliance automatically reverts to the program delay and the
adjustment is set to the chosen value.
N.B.: the display indicates the water hardness adjustment and the
program delay. A dot (.) after the number means that the water hard-
ness adjustment is being displayed. If no dot (.) appears, the pro-
gram delay is being displayed.
Rev 0.0
pr. 4 pr. 5
EN
Fig. 2-04
11