Switching On; Selecting And Starting The Program; End Of Program - Porter & Charles DW18PCFI Manuel D'utilisation

EN
Only run the soak program with half loads.
After using the above table to choose the most suitable washing cycle, pro-
gram the appliance.
2.2.1

Switching on

Press the on/off button (ref. 1 fi g. 2-02) to start the dishwasher. Then wait for
one of the program indicator lights to turn on (ref. 2 fi g. 2-02).
2.2.2

Selecting and starting the program

• Press the program selection button (ref. 3 fi g. 2-02) several times until
the indicator light corresponding to the required program turns on (ref. 2 fi g.
2-02);
• if necessary, select, using the relative buttons, the complementary functions
you are interest in (e.g. "Programming delay");
• close the door; the program will start after about 2 seconds and the relative
indicator light will fl ash throughout the cycle (program running signal).
2.2.3

End of program

The end of the program is indicated by a brief acoustic signal and the (marked
by "end") "auto delicate" and "extreme wash" program indicator lamps fl ash.
8
Before starting a washing program, make sure that:
• The water supply tap is open.
• There is regenerating salt in the water softener tank (to add
salt, see the instructions in the general manual).
• The correct amount of detergent has been added to the dis-
penser (to add detergent, see the instructions in the general
manual).
• The spray arms are able to rotate freely and without obstruction.
• The racks have been correctly loaded (see the instructions in the
general manual).
• The dishwasher door is securely closed.
If the door of the dishwasher has not been closed or has been incor-
rectly closed, the washing cycle will not begin.
USER INSTRUCTIONS
Rev 0.0