Dedicated Micros System Sprite Guide De L'utilisateur page 44

Additional Telemetry Commands
Please refer to the specific telemetry receiver manuals for a more detailed explanation of the functions listed below. The
DM/DTMF receiver has an extended telemetry feature set that is beyond the scope of this manual, refer to the DR4 Receiver
manual for full details.
Command Range, if applicable
-
*862005
DM/DTMF 000 to 099
*883xxx BBV 000 to 015
Pelco 000 to 031
-
*881001
*853xxx 001 to 999
*857xxx 001 - 099
*889xxx 002 - 005
40 Guide to Operating Telemetrye
DM/DTMF BBV
Peforms auto setup procedure
including detection of all pan, tilt, Performs self test of all telemetry
lens feedback cabling and alarm receive functions
contacts.
Erases a preset Erases a preset
000 = Preset 0 (Home) 000 = Preset 1
099 = Preset 99 015 = Preset 16
Clear all presets Clear all presets
Sets the delay time within a Patrol Sets the delay time within Patrol.
that the camera dwells on a preset Pange 001 to 016,
before continuing. sets delay in increments of 12
Range 001 - 999 seconds. seconds.
Used to change the number of Used to change the number of presets
presets in a patrol from the default. in a patrol from the default. "All
"All presets stored". presets stored".
Range 001 to 099 Range 001 to 015
All 4 commands used with the BX100
dome interface to set up receiver
Not supported
dome parameters, enter/exit menus
etc.
Pelco
Preforms a remote
reset
Erases a preset
000 = Preset 1
031 = Preset 32
Clear all presets
No Patrol
supported.
No Patrol
supported.
Not supported
Version 1.0