Hilti SJT 6-A22 Mode D'emploi Original page 14

6.1 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery.
6.2 Inserting the battery
CAUTION
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the battery holder until it engages with an audible click.
3. Check that the battery is seated securely.
6.3 Removing the battery
1. Press the battery release buttons.
2. Remove the battery from the tool.
6.4 Fitting the saw blade
1. Remove the battery.
2. Push the saw blade (teeth facing the cutting direction) into the blade holder until it engages.
3. Grip and pull the saw blade to check that it is held securely.
6.5 Fitting the guard
1. Remove the battery.
2. Push the guard onto the power tool from the front until it clicks into place.
The guard can be fitted only when the base plate is in the normal position (zero degrees position).
6.6 Fitting the dust removal adapter
1. Push the dust removal adapter on to the base plate horizontally from the rear until both catches engage
at the side.
2. Connect the vacuum cleaner hose to the dust removal adapter.
7 Operation
Observe the safety instructions and warnings in this documentation and on the product.
7.1 Using a dust extractor
The dust extractor reduces dust emissions, increases working safety by providing better visibility of
the cutting line and reduces exposure to dust and wood chips at the workplace.
1. Fit the guard. → page 8
2. Always use a dust extractor when working over a lengthy period with wood or materials that can cause
high dust concentrations.
8 English
2
3
4
2150257
*2150257*