ACCO GBC FOTON 3 Manuel D'installation Et D'utilisation page 3

1. Safety
YOUR SAFETY, AS WELL AS THE SAFETY OF OTHERS IS
IMPORTANT TO ACCO. IN THIS INSTRUCTION
MANUAL AND ON THE PRODUCT ARE IMPORTANT
SAFETY MESSAGES. BEFORE YOU INSTALL OR USE
THE MACHINE, READ AND FOLLOW ALL THE SAFETY
NOTICES CAREFULLY IN THIS CHAPTER
Observe all the safety information provided.
Observe all safety warnings. Never remove safety
warnings or other information from the equipment.
Read all of the instructions and save these
instructions for further use.
The safety alert symbol precedes each safety
notice in this manual. The symbol indicates a
potential personal safety hazard to you or others, as
well as cause product damage or property damage.
This safety alert symbol indicates a potential
electrical shock. It warns you not to open the
laminator and expose yourself to hazardous voltage.
DO NOT OPEN. NO USER SERVICABLE PARTS INSIDES.
REFER SERVICING TO QUALITFIED SERVICE PERSONAL.
THE FOLLOWING WARNINGS ARE FOUND ON THE
FOTON 30 AUTOMATED LAMINATOR.
CAUTION Hot Surface: Laminator rollers can
be in excess of 260° F/ 126.7° C. Please use caution
and do not touch the rollers.
WARNING: Do not attempt to service or
repair the laminator.
.
WARNING: do not connect the
laminator to an electrical supply or attempt to
operate the laminator until you have completely
read these instructions. Maintain these
instructions in a convenient location for future
reference.
General safeguards
• Use this laminator only for its intended
purposes as according to the
specifications outlined in the operating
instructions.
• Keep hands, long hair, loose clothing and
articles such as necklaces or ties away
from the front of the feed rollers to
avoid entanglement and entrapment.
• When opening the top door of the
laminator, avoid contact with the
internal rollers when laminator is
powered on or shortly after the
laminator has been turned off. The
rollers can reach temperatures in excess
of 260º F / 126.7° C.
• Keep hands and fingers away from the
path of the sharp film cutter blade
located at the film exit.

Do not place the laminator on an
unstable cart, stand or table. An
unstable surface may cause the
laminator to fall resulting in serious
bodily injury. Avoid quick stops,
excessive force and uneven floor
surfaces when moving the laminator on
a cart or stand.
• Do not defeat or remove electrical and
mechanical safety equipment such as
interlocks, shields and guards.
• Do not insert objects unsuitable for
lamination.
• Do not expose laminator to liquids.