Specifications - Kenwood KDC-BT49DAB Mode D'emploi

TROUBLESHOOTING
Symptom Remedy
• Reduce the distance between the unit and the Bluetooth
Sound is being
interrupted or skipped audio player.
• Turn off, then turn on the unit and try to connect again.
during playback of
• Other Bluetooth devices might be trying to connect to the
a Bluetooth audio
player. unit.
• Check whether the connected Bluetooth audio player
The connected
Bluetooth audio supports Audio/Video Remote Control Profile (AVRCP).
player cannot be (Refer to the instructions of your audio player.)
• Disconnect and connect the Bluetooth player again.
controlled.
"DEVICE FULL" The number of registered devices has reached its limit. Retry
after deleting an unnecessary device. ( 15, DEVICE DELETE)
"N/A VOICE TAG" Make sure the same voice as the registered voice tag is used.
"NOT SUPPORT" The connected phone does not support Voice Recognition
feature.
"NO ENTRY" / There is no registered device connected/found via Bluetooth.
"NO PAIR"
"ERROR" Try the operation again. If "ERROR" appears again, check if the
device supports the function you have tried.
"NO INFO" Bluetooth device cannot get the contact information.
"HF ERROR XX" / Reset the unit and try the operation again. If this does not
"BT ERROR" solve the problem, consult your nearest service center.
22

SPECIFICATIONS

DAB Frequency Range
Sensitivity
Signal-to-Noise Ratio
Antenna Connector Type
Antenna Output Voltage
Antenna Maximum Current
FM Frequency Range
Usable Sensitivity (S/N = 26 dB)
Quieting Sensitivity
(DIN S/N = 46 dB)
Frequency Response (±3 dB)
Signal-to-Noise Ratio (MONO)
Stereo Separation (1 kHz)
MW Frequency Range
Usable Sensitivity (S/N = 20 dB)
LW Frequency Range
Usable Sensitivity (S/N = 20 dB)
L Band 1 452.960 MHz — 1 490.624 MHz
Band III 174.928 MHz — 239.200 MHz
–100 dBm
80 dB
SMB
14.4 V (11 V – 16 V)
< 100 mA
87.5 MHz — 108.0 MHz (50 kHz space)
0.71 μV/75 Ω
2.0 μV/75 Ω
30 Hz — 15 kHz
64 dB
40 dB
531 kHz — 1 611 kHz (9 kHz space)
28.2 μV
153 kHz — 279 kHz (9 kHz space)
50 μV