Electric Start - SNOWJOE SUNJOE SJG4100LP Manuel D'utilisation

When a cumulative run time of 20 hours has been
reached, replace the engine lubrication. After the first time
of replacing lubricant, replace the lubricant every 100
hours.
When a cumulative time of 50 hours is reached, clean the
air filter.
When a cumulative time of 100 hours is reached, clean
the spark plug.
C. 5 Volt 2 Amp USB receptacle.
D. Multi Volts (5V, 9V, 15V and 20V) USB-Type C
receptacle.
E. Main circuit breaker button – Main circuit breaker is
designed to protect the generator against overload. The
breaker will trip and the button will stick out if overload
happens. Press the main circuit beaker button to reset the
circuit.
F. 120 Volt AC 30 Amp RV receptacle.
G. 120 Volt AC 30 Amp twist lock receptacle.
H. AC circuit breaker button – AC circuit breaker is
designed to protect the AC circuit against overload. The
breaker will trip and the button will stick out if overload
happens. Press the AC circuit breaker button to reset the
circuit.
I. 120 Volt AC 20 Amp duplex receptacle.
Start the Generator

Electric start

Follow the instruction below to start the generator.
1. On a level surface with the engine off, check the lubricant
level before each use of the generator.
NOTE: If location of generator is not level, the unit may
not start or may shut down during operation.
2. Make sure there's no load plugged into the generator.
3. Open the storage compartment, and insert the battery into
the battery compartment (Fig. 20).
Fig. 20
Battery
compartment
4. Make sure the propane cylinder is tested and installed as
described, then open the cylinder valve completely
(Fig. 21).
5. Press the engine switch to ON position (Fig. 22).
Engine switch
6. Move the choke lever all the way LEFT to the START
Storage
compartment
cover
7. Press the engine switch to START position (Fig. 24).
Battery pack
Engine switch
16
position (Fig. 23).
START
position
Fig. 21
Cylinder valve
Regulator
Fig. 22
Fig. 23
Choke lever
Fig. 24