Tripp-Lite B116-002A Manuel De L'utilisateur page 6

Cascade Installation
1. Make sure the DVI and Audio source are powered OFF.
2. Connect the DVI and Audio source to the input ports on the first-level splitter using
a Tripp Lite DVI with 3.5 mm Audio Cable (P560-XXX-A Series) or a Tripp Lite Single-
Link DVI Cable (P561-Series) and 3.5 mm Audio cable (P312-Series).
3. Connect a set of available output ports on the first-level splitter to the input ports on
a second-level splitter using a Tripp Lite DVI with 3.5 mm Audio Cable (P560-xxx-A
Series) or a Tripp Lite Single-Link DVI Cable (P561-Series) and 3.5 mm Audio cable
(P312-Series).
4. Repeat step 3 for any additional splitters you wish to connect. Once you have
connected a splitter to each set of ports on the first-level splitter, you can connect a
third level of splitters to each set of ports on the second level. No more than three
levels of splitters can be connected in a cascade installation.
5. Connect a monitor and speakers to a set of available output ports using a
Tripp Lite DVI with 3.5 mm Audio Cable (P560-XXX-A Series) or a Tripp Lite Single-
Link DVI Cable (P561-Series) and 3.5 mm Audio cable (P312-Series).
6. Repeat step 5 for each additional set of monitor and speakers you are connecting.
7. Connect the included external power supply to the first-level splitter and plug it into
a Tripp Lite Surge Protector, Power Distribution Unit (PDU) or Uninterruptible Power
Supply (UPS). The Power LED will illuminate to indicate the unit is receiving power.
DVI/Audio Source
6