Volume Control; Bass Control - Sharp MD-MT90C Mode D'emploi

1
Insert the headphones plug firmly into the head-
phones socket on the remote control unit.
2
Plug the remote control into the REMOTE sock-
et on the unit.
3
Insert a MiniDisc (page 6).
4
Press the PLAY/PAUSE button.
Playback starts automatically with a playback only
MiniDisc or a MiniDisc which is protected against
accidental erasure (Auto-play function).
To interrupt playback
Press the PLAY/PAUSE button.
To resume playback, press the PLAY/PAUSE button
again.
To stop playback
Press the /:OFF button.
If the unit is not operated for at least 2 minutes whilst in
the stop mode, the power will shut off automatically.
To turn off the power
Press the /:OFF button whilst in the stop mode.

„ Volume control

Press the VOL+ button to increase the volume and the
VOL - -- button to decrease the volume.

„ Bass control

Each time the BASS button is pressed, the tone will be
switched as follows.
BASS 1 Emphasised slightly
BASS 2 Emphasised more
BASS 3 Emphasised fully
BASS OFF Cancelled
Notes:
z If power failure occurs whilst playing a disc using the AC
adaptor, disconnect it from the wall socket. Otherwise,
playback may start automatically
resumes.
z If you connect the AC adaptor without installing the
rechargeable battery, playback may start automatically. Be
sure to turn off the power.
z Reduce the volume before starting to play. MiniDiscs,
compared to ordinary cassette tapes, have very little
noise. If the volume is adjusted according to your usual
expectations of noise, high volume may damage your
hearing.
z The sound escaping from your headphones may annoy
people around you. In particularly crowded places (such
as on trains or buses), reduce the volume.
when electricity
E-12
ENGLISH